%0 Journal Article %T Site selection of the suitable areas for the physical development of Tehran megalopolis based on the climatic elements and geographic factors %A F. Mojarrad %A S. Hoseinifar %J Geography and Environmental Planning %D 2012 %I %X Extended abstract1- Introduction Developing the cities and it¡¯s influences on the spatial structure of megalopolises has always been one of the most important factors for the planners. Among the most important factors directing the development of the cities, are natural factors such as climatic ones which have been less considered in the country as yet because of various factors like economic benefits resulting from immethodical construction of the buildings. Since this carelessness has caused an unwise and easy-going development of Tehran megalopolis in unsuitable geographic directions, so this research intends to accomplish the optimum site selection for physical development of Tehran megalopolis based on climatic elements and geographic factors. 2- MethodologyTopographic maps of the region which mainly consist some parts of Tehran and Alborz provinces on a scale of 1:250,000 were prepared and the region boundary was defined on them. In the next step, the climatic data of six meteorological stations was taken from the Iranian Meteorological Organization and, after reconstruction, was considered through the similar time range of 1984 to 2005. Then, using ArcGIS software and on the basis of the climatic and geographic factors, various layers affecting the site selection including topography, digital elevation model (DEM), slope percent and aspect, solar radiation angle, temperature means (minimum, maximum and daily), mean diurnal temperature difference, 24 hrs. maximum precipitation, and mean wind speed were made and entered into the software. Pixels¡¯ values in the climatic layers were calculated via spline interpolation method or regression equations. Then the resulted raster layers, after the reclassification of their pixels¡¯ values, were weighed and overlayed using Spatial Analyst (SA) and Spatial Analytical Hierarchy Process (SAHP) models and thus the final maps of the physical development suitability of these two models were obtained.On the other hand, two Landsat ETM-7 images prepared from Iranian Space Agency and some geometric corrections were made on them using PCI (Geomatica) software in UTM WGS84 projection. Before geometric corrections, because of temporal differences of images, radiometric corrections were made on them too. radiometric correction or normalization means the reconstruction of image values so that there is a linear and similar relation between pixels and their real radiations in the whole imaging area. The result was the Normalized Difference Vegetation Index (NDVI) map and the land use map. As the last step, the final site sel %K site selection %K physical development %K Tehran %K climate %K GIS %U site selection, physical development, Tehran, climate, GIS