%0 Journal Article
%T Fabrication of Mg-Zn-Y-based quasi-crystal by pouring melt into different cooling media
%A Wang Zhifeng
%A Zhao Weimin
%A Qin Chunling
%J China Foundry
%D 2012
%I Foundry Journal Agency
%X Mg-Zn-Y-based quasi-crystal (QC) alloys were fabricated by pouring melts into different cooling media. The effects of different cooling rates on the QC morphology, size, volume fraction and micro-hardness were studied. Multi-component Mg-Zn-Y-based QC alloys were synthesized based on amorphous design principle. QC morphology transformation and its influencing factors were analyzed. Micro/nano spherical quasi-crystals (QCs) were fabricated through a wedge-shaped copper mould and their forming mechanism were discussed by atoms cluster theory, optimum cooling rate theory and the known crucial criteria. The results of research show that with the cooling rate reduced, the solidified morphology of QC phase changes from near-spherical, micro petals (1 to 2 ¦Ìm) to big petals (20 ¦Ìm) and finally grows up to bulk pentagon or hexagon (200 to 400 ¦Ìm). Multi-component micro-spherical QCs possess higher value of micro-hardness than petal-like QCs with the same components, and also higher than ternary micro-Mg-Zn-Y QCs. The fine master alloys containing micro-QCs (0.4 ¦Ìm) and nano-QCs (about 300 nm and 40 nm) have been fabricated correspondingly on the middle and the tip of wedge-shaped castings. A morphology evolution schematic diagram of Mg-Zn-Y-based QCs is included in this paper.
%K quasi-crystals
%K cooling media
%K magnesium alloy
%K Mg-Zn-Y-based alloys
%U http://www.foundryworld.com/uploadfile/2012082749391069.pdf