%0 Journal Article
%T Assessment of Cutting Parameters Influencing on Thrust Force and Torque during Drilling Particulate Filled Glass Fabric Reinforced Epoxy Composites
%A Bhadrabasol Revappa Raju
%A Bheemappa Suresha
%A Ragera Parameshwarappa Swamy
%A Bannangadi Swamy Gowda Kanthraju
%J Journal of Minerals and Materials Characterization and Engineering
%P 101-109
%@ 2327-4085
%D 2013
%I Scientific Research Publishing
%R 10.4236/jmmce.2013.13019
%X Drilling is indispensable process and it cannot be avoided for joining composite structures used in various engineering applications. In this research article, the influence of drilling parameters on thrust force and torque of silica (SiO<sub>2</sub>) and alumina (Al<sub>2</sub>O<sub>3</sub>) filled into glass fabric reinforced epoxy (G-E) composites are analyzed. Drilling experiments are conducted on these composite materials using BATLIBOI make radial drilling machine. Two different drill bits (HSS and cemented carbide) are used for the experimentation. The influence of drilling parameters like cutting speed and feed on thrust force and torque on drilling of particulate filled G-E composites has been carried out. The experimental results indicated that the thrust force and torque were increased with increasing feed and cutting speed for all the composites tested. Further, it is observed that the carbide drill performed better than HSS drill during drilling of particulate filled G-E composites. The drilled surfaces are examined using scanning electron microscopy (SEM) and damage mechanisms are discussed.
%K Particulate Filled Glass-Epoxy Composites
%K Drilling
%K Thrust Force and Torque
%K HSS and Carbide Drills
%U http://www.scirp.org/journal/PaperInformation.aspx?PaperID=31721