%0 Journal Article
%T Effect of Polymer Adsorption on Permeability Reduction in Enhanced Oil Recovery
%A Saurabh Mishra
%A Achinta Bera
%A Ajay Mandal
%J Journal of Petroleum Engineering
%D 2014
%I Hindawi Publishing Corporation
%R 10.1155/2014/395857
%X In order to reduce the permeability to water or brine, there is a possibility of polymer injection into the reservoir. In the present work, special focus has been paid in polymer [partially hydrolyzed polyacrylamide (PHPA)] injection as a part of chemical method. Tests were conducted in the laboratory at the ambient temperature to examine the reduction in permeability to water or brine in the well-prepared sand packed after the polymer injection. The experiments were performed to study the effect of polymer adsorption on permeability reduction by analyzing residual resistance factor values with different concentrations of polymer solutions. The rheological behavior of the polymer has also been examined. The experimental results also indicate that the adsorption behavior of polymer is strongly affected by salinity, solution pH, and polymer concentration. To investigate the effect of polymer adsorption and mobility control on additional oil recovery, polymer flooding experiments were conducted with different polymer concentrations. It has been obtained that with the increase in polymer concentrations, oil recovery increases. 1. Introduction With reservoir getting matured, the increased water production with producing oil is a major concern in the petroleum industry. Hydrocarbon production decreases, which affects recovery economics and disposal of the excessive high amount of underground water, which causes complex environmental problems [1]. Oil and gas reservoirs are often heterogeneous, having a different permeability in different-different layers. This causes channelling of excessive water production through high permeability layers, as a result of which large amount of movable oil and gas remains trapped in low permeability zones which results in poor recovery in primary and secondary stages of production. A significant part of the residual oil can be recovered by application of a polymer solution in the heterogeneous reservoirs [2]. The excess water production can be controlled without affecting oil production rate by using polymer to reduce the relative permeability to water more than the relative permeability to oil [3]. The injection of polymer solutions in production wells has proven to be an effective method to reduce or block excessive water production [4]. In a water-wet reservoir, oil flows inside pores while water through the annulus between the pore walls and the oil-water interface [5]. When the polymer solution is injected, it gets adsorbed on the rock surface to form a thin layer. As water flows through this zone, the adsorbed polymer
%U http://www.hindawi.com/journals/jpe/2014/395857/