%0 Journal Article
%T Improving the Demulsification Process of Heavy Crude Oil Emulsion through Blending with Diluent
%A K. K. Salam
%A A. O. Alade
%A A. O. Arinkoola
%A A. Opawale
%J Journal of Petroleum Engineering
%D 2013
%I Hindawi Publishing Corporation
%R 10.1155/2013/793101
%X In crude oil production from brown fields or heavy oil, there is production of water in oil emulsions which can either be controlled or avoided. This emulsion resulted in an increase in viscosity which can seriously affect the production of oil from sand phase up to flow line. Failure to separate the oil and water mixture efficiently and effectively could result in problems such as overloading of surface separation equipments, increased cost of pumping wet crude, and corrosion problems. Light hydrocarbon diluent was added in varied proportions to three emulsion samples collected from three different oil fields in Niger delta, Nigeria, to enhance the demulsification of crude oil emulsion. The viscosity, total petroleum hydrocarbon, and quality of water were evaluated. The viscosity of the three emulsions considered reduced by 38, 31, and 18%. It is deduced that the increase in diluent blended with emulsion leads to a corresponding decrease in the value of viscosity. This in turn enhanced the rate of demulsification of the samples. The basic sediment and water (BS&W) of the top dry oil reduces the trace value the three samples evaluated, and with optimum value of diluent, TPH values show that the water droplets are safe for disposal and for other field uses. 1. Introduction Emulsion is defined as a system in which one liquid is relatively distributed or dispersed, in the form of droplets, in another substantially immiscible liquid. Emulsions have long been of great practical interest due to their widespread occurrence in everyday life which occurs due to reliance of the behaviour of the emulsion on the magnitude and range of the surface interaction. They may be found in important areas such as food, cosmetics, pulp and paper, biological fluids, pharmaceutical, agricultural industry, and petroleum engineering. In production and flow assurance, the two commonly encountered emulsion types are water droplet dispersed in the oil phase and termed as water-in-oil emulsion (W/O) and if the oil is the dispersed phase, it is termed oil-in-water (O/W) emulsion [1]. Water-in-oil crude oil emulsions may be encountered at all stages in the petroleum production and in processing industry. With presence of water, they are typically undesirable and can result in high pumping costs and pipeline corrosions and increase the cost of transportation [2]. Reduced throughput is needed to introduce special handling equipment, contribute to plugging of gravel pack at the sand phase [3], and affect oil spill cleanup [4]. In their research work, Micheal et al. used bottle test method
%U http://www.hindawi.com/journals/jpe/2013/793101/