%0 Journal Article
%T Laser Surface Alloying of 316L Stainless Steel with Ru and Ni Mixtures
%A M. B. Lekala
%A J. W. van der Merwe
%A S. L. Pityana
%J International Journal of Corrosion
%D 2012
%I Hindawi Publishing Corporation
%R 10.1155/2012/162425
%X The surfaces of AISI 316L stainless steel were laser alloyed with ruthenium powder and a mixture of ruthenium and nickel powders using a cw Nd:YAG laser set at fixed operating parameters. The microstructure, elemental composition, and corrosion characteristics of the alloyed zone were analyzed using optical and scanning electron microscopy (SEM), energy dispersive X-ray spectroscopy (EDX), and corrosion potential measurements. The depth of alloyed zone was measured using the AxioVision program and found to be approximately 1.8£¿mm for all the alloyed specimens. Hardness profile measurements through the surface-substrate interface showed a significant increase from 160£¿HV for the substrate to a maximum of 247£¿HV for the alloyed layer. The sample laser alloyed with 80£¿wt% Ni-20£¿wt% presented the most noble corrosion potential of £¿V and the lowest corrosion current density . 1. Introduction Minor additions of ruthenium to the bulk volume of steels resulted in a significant improvement of corrosion resistance in many reducing environments [1]. Ruthenium modified alloys possesses properties which render them candidate alloys to replacing the expensive nickel-based alloys which are currently used in more aggressive corrosion environments [2]. However, owing to the high-cost associated with ruthenium, bulk alloying is currently not a feasible means, although opportunities to explore the method exist. For instance, Streicher [3] observed a synergistic benefit when ruthenium and nickel were added together to steels. This observation offers an opportunity to reduce the amount of ruthenium per bulk volume added in the alloying process, yet presents significant improved corrosion resistance. Thus, minor additions of ruthenium together with nickel present an economically sound approach of modifying corrosion properties of alloys. Furthermore, since corrosion is a surface phenomenon, an equally cost-effective approach is to add these only on the surface, where protection is most required. Laser surface modification techniques have been extensively studied for selective improvement of surfaces for wear, hardness, and corrosion [4¨C7]. The laser surface alloying technique is particularly applicable in cases where a change in the chemical composition and microstructure of the surface is required. The laser surface alloying technique enables external alloying elements to be added into the bulk material via a laser generated melt pool. Generally, the external alloy material is either preplaced on the desired surface of the substrate or fed into the melt pool. The alloy
%U http://www.hindawi.com/journals/ijc/2012/162425/