%0 Journal Article
%T Al-Si-Mg Foam Produced by 3D Printer
%A Harun KAYA
%A Nevzat BAYR£¿
%A Sel£¿uk ATALAY
%A Tekin £¿ZG£¿
%A Veli Serkan KOLAT
%J -
%D 2018
%X Al89.5Si10Mg0.5 metallic foam was produced by 3D metal printer. The design pattern has a triangular-like structure and it consists of aligned wires. The structure was designed so that the distance between wires is 1 mm and the wire diameter is 1.2 mm. X-ray results showed that sample has a cubic structure with nm grains. Also, detailed element mapping indicated that sample has a homogenous distribution state of the reinforcement throughout the Al matrix, which also a clear indication of single phase. Compressive stress¨Cstrain curves shows the typical compressive behaviour of metallic foams consists of a narrow linear elastic area followed by a plateau regime and then a sharp increase
%K 3D yaz£¿c£¿ taraf£¿ndan ¨¹retilen Al-Si-Mg k£¿p¨¹k
%U http://dergipark.org.tr/adyusci/issue/38036/383716