%0 Journal Article
%T Determination of Curie Point Depth and Heat Flow Using Airborne Magnetic Data over the Kom-Ombo and Nuqra Basins, Southern Eastern Desert, Egypt
%A Ahmed Tarshan
%A Asmaa A. Azzazy
%A Ali M. Mostafa
%A Ahmed A. Elhusseiny
%J Geomaterials
%P 91-108
%@ 2161-7546
%D 2023
%I Scientific Research Publishing
%R 10.4236/gm.2023.134007
%X The Kom-Ombo and Nuqra basins in southern Egypt have recently been discovered as potential hydrocarbon basins. The lack of information about the geothermal gradient and heat flow in the study area gives importance to studying the heat flow and the geothermal gradient. Several studies were carried out to investigate the geothermal analyses of the northwestern desert, as well as the west and east of the Nile River, using density, compressive wave velocity, and bottom hole temperature (BHT) measured from deep oil wells. This research relies on spectral analysis of airborne magnetic survey data in the Kom-Ombo and Nuqra basins in order to estimate the geothermal gradient based on calculating the depth to the bottom of the magnetic source that caused the occurrence of these magnetic deviations. This depth is equal to the CPD, at which the material loses its magnetic polarisation. This method is fast and gives satisfactory results. Usually, it can be applied as a reconnaissance technique for geothermal exploration targets due to the abundance of magnetic data. The depth of the top (<em>Z<sub>t</sub></em>) and centroid (<em>Z</em><sub>0</sub>) of the magnetic source bodies was calculated for the 32 windows representing the study area using spectral analysis of airborne magnetic data. The curie-isotherm depth, geothermal gradient, and heat flow maps were constructed for the study area. The results showed that the CPD in the study area ranges from 13 km to 20 km. The heat flow map values range from 69 to 109 mW/m<sup>2</sup>, with an average of about 80 mW/m<sup>2</sup>. The calculated heat flow values in the assigned areas (A, B, C, and D) of the study area are considered to have high heat flow values, reaching 109 mW/m<sup>2</sup>. On the other hand, the heat flow values in the other parts range from 70 to 85 mW/m<sup>2</sup>. Since heat flow plays an essential role in the maturation of organic matter, it is recommended that hydrocarbon accumulations be located in places with high heat flow values, while deep drilling of hydrocarbon wells is recommended in places with low to moderate heat flow values.
%K Curie Point
%K Heat Flow
%K Airborne Magnetic Data
%K Nuqra Basin
%K Kom-Ombo Basin
%K Eastern Desert
%U http://www.scirp.org/journal/PaperInformation.aspx?PaperID=128043