Composite Zones Produced In Situ in the Ni3Al Phase

The study presents the results of research on the development of composite zones in castings based on the intermetallic phase of Ni3Al.Composite zones were obtained by placing packets with substrates for the reaction of titanium carbide in a foundry mould. To provide avariable carbides content in the composite zone, two compositions of the packets were prepared. The first packet contained only substratesfor the reaction of TiC synthesis; the second one also contained a filler. The resulting composite zones in castings were examined for the filler effect on changes in the volume fraction, size and morphology of carbides in the zone. In addition, the effect of filler on the mechanical properties of the zone was verified, observing changes of Vickers hardness in this area. It was found that the presence of filler in the composition of the packet for synthesis reduced the content of carbides, as well as their size and morphology. Lower surface content of carbides reduced hardness of the zone, which enabled smooth control of the mechanical properties. At the same time, the use of the selected filler did not disturb the course of the TiC carbide synthesis.