Strut elaboration in strut-and-tie model

The Strut-and-Tie Model (STM) has been incorporated into the codes and standards because of its consistency and rationality since last decade. However, it has encountered few challenges whilst its implementation. The effective compressive strength of strut has been a complex issue among researchers since emergence of STM. This review serves as a base for future developments of STM. It addresses several ways towards enhancing our understanding of strut performance in the STM. It also throws up questions for further investigation of effective compressive strength of strut in the STM. This review is confined to the evaluation of strut effectiveness factor based on the available codes and standards particularly AASHTO LRFD and ACI 318-08. According to the example given in this paper, there is sometimes a marked difference of approximately 50% between strut effectiveness factor recommended by AASHTO LRFD and ACI 318-08. More broadly, research is needed to determine which of the complicated strut effectiveness factor recommended by AASHTO LRFD and the simple one recommended by ACI 318-08 is optimum.