全部 标题 作者
关键词 摘要

OALib Journal期刊
ISSN: 2333-9721
费用:99美元

查看量下载量

相关文章

更多...

Parking Strategies for Vertical Axis Wind Turbines

DOI: 10.5402/2012/904269

Full-Text   Cite this paper   Add to My Lib

Abstract:

Strategies for parking a vertical axis wind turbine at storm load are considered. It is proposed that if a directly driven permanent magnet synchronous generator is used, an elegant choice is to short-circuit the generator at storm, since this makes the turbine efficiently damped. Nondamped braking is found to be especially problematic for the case of two blades where torsional oscillations may imply thrust force oscillations within a range of frequencies. 1. Introduction It has become increasingly important to broaden the search for potential technologies for renewable energy conversion, as part of the joint effort to cut greenhouse gas emissions. Within wind power, the established and through incentives now commercially viable technology of horizontal axis wind turbines (HAWTs) has attracted most of the attention during the last decades. Modern HAWTs rely on a quite impressive list of moveable parts for its function, for example, individually pitchable blades and usually a gearbox-expensive and maintenance demanding matters [1], which in part explains the incentives dependence. Another concept for harnessing wind power, the vertical axis wind turbine (VAWT), has the inherent potential to reduce the number of moving parts as pitch and yaw mechanisms are not needed [2]. The generator of VAWTs may conveniently be placed on ground level, facilitating use of bulky direct drive generators which may be optimized for low cost rather than low weight. Patented already in the 30’s by Darrieus [3], the VAWT concept was studied quite intently during the 70’s and 80’s [4, 5], but since then the major resources have been directed towards HAWTs. VAWT activities in the mean time have mostly been concentrated to small-scale turbines where the technology has indeed been successfully commercialized [6, 7]. Renewed interest in larger-scale turbines has arisen lately, especially in the context of offshore applications where the low center of gravity may be advantageous [4]. For the large-scale VAWT prototypes that have been demonstrated so far (i.e., those constructed in the 70’s and 80’s), the aerodynamic efficiency is of the order of 35–40%, which is somewhat lower than for HAWT. The challenge is, therefore, to reach a point where manufacturing and maintenance costs of VAWTs, as compared to HAWTs, are at least 20% lower per swept area, in order to render the concept viable. In this study, a straight-bladed VAWT, also called H-rotor, is considered. A 200?kW prototype H-rotor with direct drive has recently been manufactured based on research from Uppsala University [8–10];

References

[1]  L. Fingersh, M. Hand, and A. Laxson, “Wind turbine design cost and scaling model,” Tech. Rep. NREL/TP-500-40566, National Renewable Energy Laboratory, Golden, Colo, USA, 2006.
[2]  S. Eriksson, H. Bernhoff, and M. Leijon, “Evaluation of different turbine concepts for wind power,” Renewable and Sustainable Energy Reviews, vol. 12, no. 5, pp. 1419–1434, 2008.
[3]  G. Darrieus, “Turbine having its rotating shaft transverse to the ow of the current,” US patent 1.835.018, December 1931.
[4]  H. Sutherland, D. Berg, and T. Ashwill, “A retrospective of VAWT technology,” Tech. Rep. SAND2012-0304, Sandia National Laboratories, Albuquerque, NM, USA, 2012.
[5]  I. D. Mays and C. A. Morgan, “The 500 kW VAWT 850 demonstration project,” in Proceedings of the European Wind Energy Conference, 1989.
[6]  H. Riegler, “HAWT versus VAWT: small VAWTs find a clear niche,” Refocus, vol. 4, no. 4, pp. 44–46, 2003.
[7]  A. Bowen, A. Huskey, H. Link, et al., “Small wind turbine testing results from the national renewable energy laboratory,” in Proceedings of the International Small Wind Conference, Glasgow, Scotland, 2010, NREL/CP-500-48089.
[8]  S. Eriksson, H. Bernhoff, and M. Leijon, “A 225kW direct driven PM generator adapted to a vertical axis wind turbine,” Advances in Power Electronics, vol. 2011, Article ID 239061, 7 pages, 2011.
[9]  J. Kjellin, S. Eriksson, and H. Bernhoff, “Electric control substituting pitch control for large wind turbines,” Submitted to Renewable Energy.
[10]  J. Kjellin, F. Bülow, S. Eriksson, P. Deglaire, M. Leijon, and H. Bernhoff, “Power coefficient measurement on a 12?kW straight bladed vertical axis wind turbine,” Renewable Energy, vol. 36, no. 11, pp. 3050–3053, 2011.
[11]  R. E. Sheldahl and P. C. Klimas, “Aerodynamic characteristics of seven symmetrical airfoil sections through 180-degree angle of attack for use in aerodynamic analysis of vertical axis wind turbines,” Tech. Rep. SAND80-2114, Sandia National Laboratories, Albuquerque, NM, USA, 1981.
[12]  P. Klimas and M. Worstell, “Effects of blade preset pitch/offset on curved-blade darreius vertical-axis wind turbine performance,” Tech. Rep. SAND81-1762, Sandia National Laboratories, Albuquerque, NM, USA, 1981.

Full-Text

Contact Us

[email protected]

QQ:3279437679

WhatsApp +8615387084133