This article presents a comparative analysis of the properties of cotton yarn spun on aerodynamic compact spinning and open-end rotor spinning systems. Yarn samples with a linear density of 50 Tex, 37 Tex, 30 Tex, 25 Tex, and 20 Tex were spun both on the aerodynamic compact and rotor spinning systems using the same finisher drawn sliver of medium staple cotton which were produced by a specific mixing. The quality parameters such as mass variation, imperfection index, hairiness, and tensile behavior (strength in count strength product, elongation percentage) of the yarn samples were assessed and analyzed. The results revealed that aerodynamic compact spun yarn had a lower unevenness and mass variation, a higher imperfection in case of a finer count, less hairiness, higher tensile strength, and lower elongation% compared to the open-end rotor spun yarn samples. Finally, paired- samples t-test and regression analysis were carried out by using IBM SPSS 25 to check the significance of yarn quality parameters and correlation among them.
Dan Hasanuzzaman, P.K. and Basu, S. (2015) Optimization of Ring-Spinning Process Parameters Using Response Surface Methodology. The Journal of The Textile Institute, 106, 510-522. https://doi.org/10.1080/00405000.2014.929250
[3]
Cheng, K.P.S. and Yu, C. (2003) A Study of Compact Spun Yarns. Textile Research Journal, 73, 345-349. https://doi.org/10.1177/004051750307300412
[4]
Soe, A.K., Takahashi, M., Nakajima, M., Matsuo, T. and Matsumoto, T. (2004) Structure and Properties of MVS Yarns in Comparison with Ring Yarns and Open-End Rotor Spun Yarns. Textile Research Journal, 74, 819-826. https://doi.org/10.1177/004051750407400911
[5]
Basal, G. and Oxenham, W. (2006) Comparison of Properties and Structures of Compact and Conventional Spun Yarns. Textile Research Journal, 76, 567-575. https://doi.org/10.1177/0040517506065591
[6]
Rameshkumar, C., Anandkumar, P., Senthilnathan, P., Jeevitha, R. and Anbumani, N. (2008) Comparative Studies on Ring Rotor and Vortex Yarn Knitted Fabrics. Autex Research Journal, 8, 100-105.
[7]
Khurshid, M.F., Nadeem, K., Asad, M., Chaudhry, M.A. and Amanullah, M. (2013) Comparative Analysis of Cotton Yarn Properties Spun on Pneumatic Compact Spinning Systems. Fibres & Textiles in Eastern Europe, 21, 30-34.
[8]
Göktepe, F., Yilmaz, D. and Göktepe, Ö. (2006) A Comparison of Compact Yarn Properties Produced on Different Systems. Textile Research Journal, 76, 226-234. https://doi.org/10.1177/0040517506061241
[9]
Nikolić, M., Stjepanovič, Z., Lesjak, F. and Štritof, A. (2003) Compact Spinning for Improved Quality of Ring-Spun Yarns. Fibres & Textiles in Eastern Europe, 11, 30-35.
[10]
Kumar, A., Ishtiaque, S. and Salhotra, K. (2003) Compact Spinning: A Critical Review. Paper No: IMECE2003-55321, American Society of Mechanical Engineers, Washington DC. https://doi.org/10.1115/IMECE2003-55321
[11]
Altas, S. and Kadoğlu, H. (2012) Comparison of Conventional Ring, Mechanical Compact and Pneumatic Compact Yarn Spinning Systems. Journal of Engineered Fibers and Fabrics, 7, 87-100. https://doi.org/10.1177/155892501200700201
[12]
Chellamani, K. (2000) Compact Spinning: Spinning of the Future. Asian Textile Journal, 9, 30-33.
Brunk, N. (2002) Three Years of Practical Experience with the Elite CompactSet in Short-Staple Spinning. Spinnovation, 3, 11.
[15]
Zhibin, L.C.Z. (2009) Application of Suessen Compact Spinning Special Parts. Cotton Textile Technology, 9.
[16]
Basal, G. (2003) The Structure and Properties of Vortex and Compact Spun Yarns, in Fiber and Polymer Science. North Carolina State University, Raleigh.
[17]
Stahlecker, P. (2003) EliTe CompactSet. Recent Developments and Applications. 62nd Plenary Meeting of the International Cotton Advisory Committee, Gdańsk, 07-12 September 2003.
[18]
Jackowski, T., Cyniak, D. and Czekalski, J. (2004) Compact Cotton Yarn. Fibers &. Text in Eastern Europe, 12, 22-26.
[19]
Lehmann, B. and Herzberg, C. (2016) Yarn Constructions and Yarn Formation Techniques. In: Cherif, C., Ed., Textile Materials for Lightweight Constructions, Springer, Berlin, Heidelberg, 103-157. https://doi.org/10.1007/978-3-662-46341-3_4
[20]
Grosberg, P. and Mansour, S. (1975) High-Speed Open-End Rotor-Spinning. The Journal of the Textile Institute, 66, 89-396. https://doi.org/10.1080/00405007508630531
[21]
Yilmaz, D., Göktepe, F., Göktepe, Ö. and Kremenakova, D. (2007) Packing Density of Compact Yarns. Textile Research Journal, 77, 661-667. https://doi.org/10.1177/0040517507078796
Çelik, P. and Kadoglu, H. (2004) A Research on the Compact Spinning for Long Staple Yarns. Fibres & Textiles in Eastern Europe, 12, 27-31.
[24]
Czekalski, J., Cyniak, D., Jackowski, T. and Sieradzki, K. (2007) Quality of Wool-Type Compact Yarns from Twisted and Rubbed Roving. Fibres & Textiles in Eastern Europe, 15, 38-44.
[25]
Dash, J.R., Ishtiaque, S. and Alagirusamy, R. (2002) Properties and Processibility of Compact Yarns. Indian Journal of Fibre & Textile Research, 27, 362-368.
[26]
Krifa, M. and Ethridge, M.D. (2006) Compact Spinning Effect on Cotton Yarn Quality: Interactions with Fiber Characteristics. Textile Research Journal, 76, 388-399. https://doi.org/10.1177/0040517506062648
[27]
Jiang, X., Hu, J.L., Cheng, K.P.S. and Postle, R. (2005) Determining the Cross-Sectional Packing Density of Rotor Spun Yarns. Textile Research Journal, 75, 233-239. https://doi.org/10.1177/004051750507500308
[28]
Guo, Y., et al. (2018) Influence of Rotor Speed on Yarn Property and Structure. Cotton Textile Technology, 3, 10.
[29]
Ghosh, A. (2006) Studies on Structural Aspects of Ring, Rotor Air Jet and Open-End Friction Spun Yarns. 2006 National Conference on Emerging Trends in Textile, Fibre & Apparel Engineering, Government College of Engineering & Textile Technology, Berhampore.
[30]
Artzt, P. (1997) The Special Structure of Compact Yarns-Advantages in Downstream Processing, ITB Yarn Fab. Form, 2, 41-48.
[31]
Stalder, H. (2000) Ring-Spinning Advance. Textile Asia, 3, 43-46.
[32]
Omeroglu, S. and Ulku, S. (2007) An Investigation about Tensile Strength, Pilling and Abrasion Properties of Woven Fabrics Made from Conventional and Compact Ring-Spun Yarns. Fibres & Textiles in Eastern Europe, 15, 39-42.
[33]
Skenderi, Z., Kopitar, D., Ražić, S.E. and Iveković, G. (2019) Study on Physical-Mechanical Parameters of Ring, Rotor and Air-Jet-Spun Modal and Micro Modal Yarns. Tekstilec, 62, 42-53. https://doi.org/10.14502/Tekstilec2019.62.42-53
[34]
Kumar, A., Salhotra, K. and Ishtiaque, S. (2006) Analysis of Spinning Process Using the Taguchi Method. Part V: Effect of Spinning Processvariables on Physical Properties of Ring, Rotor and Air-Jet Yarns. The Journal of The Textile Institute, 97, 463-473. https://doi.org/10.1533/joti.2005.0111
[35]
Arain, F.A., Tanwari, A., Hussain, T. and Malik, Z.A. (2012) Multiple Response Optimization of Rotor Yarn for Strength, Unevenness, Hairiness and Imperfections. Fibers and Polymers, 13, 118-122. https://doi.org/10.1007/s12221-012-0118-8
[36]
Ahmed, S., Alimuzzaman, S. and Monjurul Haque, A.K.M. (2020) Effect of Shed Geometry on Starting Mark of Woven Fabric. SN Applied Sciences, 2, Article No. 602. https://doi.org/10.1007/s42452-020-2384-1
[37]
Skenderi, Z., Kopitar, D., Vrljičak, Z. and Iveković, G. (2018) Unevenness of Air-Jet Spun Yarn Comparison with Ring and Rotor Spun Yarn Made from Micro Modal Fibers. Tekstilec, 67, 14-26.
[38]
USTER® (2009) The Uster® Tester 5. https://www.uster.com/fileadmin/user_upload/customer/customer/Knowledge/Textile_Know_ How/Yarn_testing/U_T5_How_to_avoid_hairiness.pdf
[39]
Nurwaha, D. and Wang, X.H. (2008) Comparison of the New Methodologies for Predicting the CSP Strength of Rotor Yarn. Fibers and Polymers, 9, 782-784. https://doi.org/10.1007/s12221-008-0122-1
[40]
Hearle, J.W. and Morton, W.E. (2008) Physical Properties of Textile Fibres. 4th Edition, Elsevier, Amsterdam, 796.
[41]
Su, X.Z., Gao, W.D., Liu, X.J., Xie, C.P. and Xu, B.J. (2015) Research on the Compact-Siro Spun Yarn Structure. Fibres and Textiles in Eastern Europe, 23, 54-57.
[42]
Moučková, E., Mertová, I., Jirásková, P., Krupincová, G. and Křemenáková, D. (2015) Properties of Viscose Vortex Yarns Depending on Technological Parameters of Spinning. Autex Research Journal, 15, 138-147. https://doi.org/10.2478/aut-2014-0046
[43]
Schwarz, E.R. (1951) Certain Aspects of Yarn Structure. Textile Research Journal, 21, 125-136. https://doi.org/10.1177/004051755102100301
[44]
Petrulis, D. and Petrulyte, S. (2017) Packing Properties of Fibres in the Open- Packed Yarn Mode. Fibres & Textiles in Eastern Europe, 25, 57-61. https://doi.org/10.5604/12303666.1228171
