全部 标题 作者
关键词 摘要

OALib Journal期刊
ISSN: 2333-9721
费用:99美元

查看量下载量

相关文章

更多...

典型有机绝缘材料电痕化过程气体释放规律研究
Study on Gas Release during Electric Tracking Process of Typical Organic Insulating Materials

DOI: 10.12677/JEE.2023.112007, PP. 53-63

Keywords: 有机绝缘材料,电痕化,气体分析
Organic Insulating Materials
, Electric Tracking, Gas Analysis

Full-Text   Cite this paper   Add to My Lib

Abstract:

为更好的实现气体组分分析法在中高压开关柜绝缘状态预测评估这一领域的应用,本文对典型有机绝缘材料(环氧树脂、硅橡胶、SMC)电痕化过程气体释放规律进行研究。选取非甲烷总烃、氢气、一氧化碳作为监测目标物,重点研究典型有机绝缘材料经过不同温、湿度处理后,在电痕化过程中目标气体浓度变化规律。典型有机绝缘材料环氧树脂、硅橡胶、SMC电痕化过程会产生非甲烷总烃(NMHC)、氢气、一氧化碳气体,且在电痕化过程中生成气体浓度为氢气 > 非甲烷总烃(NMHC) > 一氧化碳;典型有机绝缘材料环氧树脂、硅橡胶、SMC在预处理条件温度(25℃~150℃)、湿度(50%~98%)变化范围内,电痕化过程中气体释放量与样条预处理的温度和湿度呈正相关的关系,即预处理温度越高、湿度越大,电痕化过程中气体释放量越大;在预处理条件温度(25℃~150℃)、湿度(50%~98%)变化范围内,典型有机绝缘材料环氧树脂、硅橡胶、SMC的耐电痕性能与温、湿度不构成简单的正相关或负相关关系,需要进一步进行重点研究。
In order to better realize the application of gas component analysis method in the field of insula-tion state prediction and evaluation of medium and high voltage switchgear, this paper studies the gas release law of typical organic insulating materials (epoxy resin, silicone rubber, SMC) during electrical tracking process. Non-methane total hydrocarbon, hydrogen and carbon monoxide were selected as monitoring targets, focusing on the study of the concentration changes of target gas in the process of electrical tracking after typical organic insulating materials were treated with different temperature and humidity. Typical organic insulating materials such as epoxy resin, silicone rubber and SMC electrical tracking process will produce non-methane total hydrocarbon (NMHC), hydrogen and carbon monoxide gas, and the gas concentration is hydrogen > non-methane total hydrocarbon (NMHC) > carbon monoxide. In the range of temperature (25?C~150?C) and humidity (50%~98%) of the pretreatment conditions, the gas release in the process of electric tracing is positively correlated with the temperature and humidity of the spline pretreatment, that is, the higher the temperature and humidity of the pretreatment, the greater the gas release in the process of electric tracking. In the range of temperature (25?C~150?C) and humidity (50%~98%) under pretreatment conditions, the electric tracking resistance of typical organic insulating materials such as epoxy resin, silicone rubber and SMC does not form a simple positive or negative correlation with temperature and humidity, which requires further focus research.

References

[1]  张雷. 高压开关柜绝缘事故的分析及防范措施[J]. 通信电源技术, 2019, 6(36): 151-153.
[2]  任美杰, 谢启源, 宋思齐. 高压开关柜阻燃绝缘件在役老化诱发着火事故的综合分析[J]. 火灾科学, 2022, 2(31): 120-128.
[3]  杜伯学. 有机绝缘耐电痕性的评定与发展[J]. 高电压技术, 2005, 5(31): 10-13.
[4]  田付强, 彭潇. 耐电晕耐电痕化绝缘材料研究进展[J]. 电工技术学报, 2017, 16(32): 3-13.
[5]  宋思齐, 任美杰, 李成钢, 等. 高压击穿电弧作用下SMC绝缘隔板引燃特性[J]. 消防理论研究, 2022, 41(7): 888-894.
[6]  冯春涛. SMC不饱和聚酯玻璃纤维绝缘隔板的研制和在高压电器开关上的应用[J]. 绝缘材料通讯, 1993(1): 11-14.
[7]  景皓, 庞先海, 张智远, 等. 高压开关柜内绝缘隔板放电原因分析及防范措施[J]. 河北电力技术, 2018, 37(5): 42-45.
[8]  董兴海. 金属封闭柜内带电运行设备局部放电检测研究[J]. 云南电力技术, 2006, 34(4): 25-26.
[9]  邱昌容, 王乃庆, 等. 电工设备局部放电及其测试技术[M]. 北京: 机械工业出版社, 1994.
[10]  彭超, 雷清泉. 局部放电超高频信号时频特性与传播距离的关系[J]. 高电压技术, 2013, 39(2): 348-353.
[11]  韩盈芝, 韦筱香. 气相色谱法测定气体中一氧化碳、二氧化碳和甲烷含量测量不确定度的评定[J]. 杭氧科技, 2013(3): 21-25.
[12]  张晓星, 任江波, 李毅, 等. SF6分解组分的红外光谱定量测定[J]. 高电压技术, 2010, 36(3): 584-589.
[13]  王先锋, 刘志远, 孙榕, 等. 严酷环境条件下使用的电气绝缘材料 评定耐电痕化和蚀损的试验方法. GBT 6553-2014 [S]. 北京: 中国国家标准化管理委员会, 2014.
[14]  刘衍, 尹桂来, 龙国华, 等. 应用理化分析探索40.5 kV开关柜绝缘隔板放电原因[J]. 高压电气, 2019, 55(9): 222-229.

Full-Text

comments powered by Disqus

Contact Us

service@oalib.com

QQ:3279437679

WhatsApp +8615387084133

WeChat 1538708413