A two-dimensional numerical model of opposed flow flame spread over thin solid fuel is formulated and modeled to study the effect of gas phase heat sink (a wire mesh placed parallel to the fuel surface) on the flame-spread rate and flame extinction. The work focuses on the performance of the wire mesh in microgravity environment at an oxygen concentration 21%. The simulations were carried out for various mesh parameters (wire diameter, “ ” and number of wires per unit length, “ ”) and mesh distance perpendicular to fuel surface “ ”. Simulations show that wire mesh is effective in reducing flame-spread rate when placed at distance less than flame width (which is about 1？cm). Mesh wire diameter is determined not to have major influence on heat transfer. However, smaller wire diameter is preferred for better aerodynamics and for increasing heat transfer surface area (here prescribed by parameter “ ”). Flame suppression exhibits stronger dependence on number of wires per unit length; however, it is relatively insensitive to number of wires per unit length beyond certain value (here 20？cm？1). 1. Introduction Diffusion flames formed over condensed fuels are well known to spread along the surface of the fuel by heat transfer from flame to fuel surface ahead of the flame. The heat transferred from the flame to the fuel pyrolyzes it to vapors which upon mixing with surrounding air form a combustible mixture. This combustible mixture is ignited by the flame behind and hence advances forward over the surface of the fuel. The study of flame spread phenomena is primarily driven by the need to have better fire safety, by means of enhanced understanding of the mechanisms that control the spread rates and extinction. Traditionally, the flame spread phenomena over solid fuels are studied under two basic categories: opposed flow flame spread and concurrent flow flame spread. This classification is based on the relative direction of flame spread with respect to the ambient gas velocity vector. In opposed flow flame spread, the flame spreads against the flow direction and in concurrent flow flame spread, the flame spreads in the direction of flow. Present work relates to the study of opposed flow spreading flame on thin solid fuel (cellulose sheets with area density 57？g/cm2) in zero gravity. Following the classical work of De Ris [1] on opposed flow spreading flames in 1969, over the last four decades research works have contributed significantly to the improvement in the understanding of the flame spread phenomena. The works [2–7] provide an excellent review on the
References
[1]
J. N. De Ris, “Spread of a laminar diffusion flame,” Symposium (International) on Combustion, vol. 12, no. 1, pp. 241–252, 1969.
[2]
F. A. Lastrina, R. S. Magee, and R. F. McAlevy III, “Flame spread over fuel beds: solid-phase energy considerations,” Symposium (International) on Combustion, vol. 13, no. 1, pp. 935–948, 1971.
[3]
W. A. Sirignano, “A critical discussion of theories of flame spread across solid and liquid fuels,” Combustion Science and Technology, vol. 6, no. 1-2, pp. 95–105, 1972.
[4]
S. R. Ray, Flame spread over solid fuels [Ph.D. thesis], Princeton University, 1981.
[5]
A. C. Fernandez-Pello and S. T. Hirano, “Controlling mechanisms of flame spread,” Combustion Science and Technology, vol. 32, pp. 1–33, 1983.
[6]
I. S. Wichman, “Theory of opposed-flow flame spread,” Progress in Energy and Combustion Science, vol. 18, no. 6, pp. 553–593, 1992.
[7]
W. A. Sirignano and D. N. Schiller, “Mechanisms of flame spread across condensed phase fuels,” in Physical and Chemical Aspects to Combustion, F. L. Dryer and R. F. Sawyer, Eds., pp. 353–407, Gordon and Breach Science Publishers, 1997.
[8]
S. L. Olson, F. J. Miller, S. Jahangirian, and I. S. Wichman, “Flame spread over thin fuels in actual and simulated microgravity conditions,” Combustion and Flame, vol. 156, no. 6, pp. 1214–1226, 2009.
[9]
X. Zhang and Y. Yu, “Experimental studies on the three-dimensional effects of opposed-flow flame spread over thin solid materials,” Combustion and Flame, vol. 158, no. 6, pp. 1193–1200, 2011.
[10]
C. Kumar and A. Kumar, “On the role of radiation and dimensionality in predicting flow opposed flame spread over thin fuels,” Combustion Theory and Modelling, vol. 16, no. 3, pp. 537–569, 2012.
[11]
C. Kumar and A. Kumar, “Opposed flow flame spread over thin solid fuels: a 2D numerical study on flame-spread transition from normal gravity to zero gravity and vice versa,” International Journal of Aerospace Innovations, vol. 1, pp. 175–187, 2009.
[12]
A. Kumar, A numerical model of opposed flow flame spread over thin solid fuels [Ph.D. thesis], Case Western Reserve University, Cleveland, Ohio, USA, 2004.
[13]
M. D. Smooke and V. Giovangigli, Formulation of the Premixed and Nonpremixed Test Problem, vol. 384 of Lecture Notes in Physics, chapter 1, Springer, New York, NY, USA, 1991.
[14]
R. K. Rajput, Heat and Mass Transfer, S. Chand & Company, New Delhi, India, 2001.
[15]
S. Bhattacharjee and R. A. Altenkirch, “A comparison of theoretical and experimental results in flame spread over thin condensed fuels in a quiescent, microgravity environment,” Symposium (International) on Combustion, vol. 24, no. 1, pp. 1669–1676, 1992.
[16]
K. Tolejko, J. Kleinhenz, A. Kumar, R. Pettegrew, and J. S. T’ien, “Downward flame spread over a composite thin solid: comparison of experimental and model results,” in Proceedings of the 4th Joint Meeting of U.S Sections of the Combustion Institute, 2005.
[17]
D. Balsara, “Fast and accurate discrete ordinates methods for mutlidimensional radiative transfer. Part I, basic methods,” Journal of Quantitative Spectroscopy and Radiative Transfer, vol. 69, no. 6, pp. 671–707, 2001.
[18]
H. Bedir, J. S. T'ien, and H. S. Lee, “Comparison of different radiation treatments for a one-dimensional diffusion flame,” Combustion Theory and Modelling, vol. 1, no. 4, pp. 395–404, 1997.
[19]
J. L. Rhatigan, H. Bedir, and J. S. T'ien, “Gas-phase radiative effects on the burning and extinction of a solid fuel,” Combustion and Flame, vol. 112, no. 1-2, pp. 231–241, 1998.
[20]
C. L. Tien, “Thermal radiation properties of gases,” in Advances in Heat Transfer, T. F. Irvine Jr, and J. P. Hartnett, Eds., vol. 5, pp. 234–254, Academic Press, New York, NY, USA, 1968.
[21]
S. V. Patankar, Numerical Heat Transfer and Fluid Flow, Hemisphere, New York, NY, USA, 1980.
[22]
I. S. Wichman, “Theory of opposed-flow flame spread,” Progress in Energy and Combustion Science, vol. 18, no. 6, pp. 553–593, 1992.
[23]
V. Malhotra and A. Kumar, “Effect of gas phase heat sink on suppression of downward flame spread over thin solid fuels,” International Journal of Advances in Engineering Sciences and Applied Mathematics, vol. 4, no. 3, pp. 138–151, 2012.
[24]
G. Grayson, K. R. Sacksteder, P. V. Ferkul, and J. S. T'ien, “Flame spreading over a thin solid in low-speed concurrent flow-drop tower experimental results and comparison with theory,” Microgravity Science and Technology, vol. 7, no. 2, pp. 187–195, 1994.
[25]
M. K. Wolverton, R. A. Altenkirch, and L. Tang, “Implementing multi-step chemical kinetics models in opposed-flow flame spread over cellulose and a comparison to single-step chemistry,” Combustion and Flame, vol. 118, no. 1-2, pp. 281–292, 1999.
[26]
K. Tolejko, I. I. Feier, and J. S. T’ien, “Effects of fuel Lewis number on flame spread over solids,” Proceedings of the Combustion Institute, vol. 30, no. 2, pp. 2263–2270, 2005.
